ハートマグこれをすれば上手に作れる！コツを徹底解説！

ハートマグこれをすれば上手に作れる！コツを徹底解説！

Hello, this is Miki Nohara from Koi Art Director. Today, I would like to demonstrate how to use the heart magnet, which is a hot topic on social media, and the points that I wish I had known earlier, along with my own explanation . Please watch till the end.

Now let’s make the wire needed for the heart magnet. I think the most important thing for heart magnets is making this wire. I tried making it using a lot of different wires, but the one that had the best magnet response was this paperback paper clip. Other than that, I

Tried using steel wire, and although I can’t make hearts, this one had the best response, so I hope you all can use wires like this that stick to magnets around you. I think it would be a good idea to try it out with a variety of wires if you have them . Today

We’re going to use this clip, which you’ll definitely have at home. Well, it’s very dangerous to do it with bare hands , so please prepare pliers like this. All of these items are available at 100 yen stores, so I

Think it would be a good idea to have several different types of pliers on hand. These are the nippers that will be used to cut the wire. Prepare these things. Here we go. First, use these pliers to straighten the clip once. It’s really dangerous, so please be careful

Not to get hurt as you stretch. If you use pliers, it’s surprisingly easy to straighten the paperclip. Okay, just like this, stretch the paperclip once straight into a wire. From here we will make the wire to make the heart. If you stretch out this paper clip, it will be about 9cm long.I’m

Going to bend it a little bit from now on, but I don’t know what to say… If you bend it according to your own guideline, it will end up becoming shorter. ,Also, there are times when it will fail, so if you don’t want to fail,

Use this 9cm wire. Open 4cm and 1cm and make a little mark in the shape of 4cm. I made two black dots here with a permanent marker beforehand. Don’t you understand? I think it’s a little hard to understand , but there are two black dots.

Once this mark is made, bend it once. Okay, now use pliers to bend it. There is a dot here, so hold this dot with pliers and bend it inward. It is like this. Then it’s on the other side. Place the pliers on the other side where you made this mark and bend it.

Yes, I’m going to bend it a little bit like this with a width of 1cm. After this, cross the ends and twist, but if the width here is narrow, it will be difficult to twist. So, if you make it a little bit wide at first, about 1cm,

It will twist well. Okay, so here, I’m going to cross the tips a little bit here, and I’ve tried a lot of things here, and I ‘m going to cross them like this, but I’m going to make this wire just a little bit like this from the beginning. On the inside

, if you bend it a little bit inward like this, it will make it easier to cross, so I think it’s a good idea to make it a little bit like this first. Cross here. Cross it so that the tip forms a Y

Like this, then grab the waiting part here with pliers. Like this, I’m going to grab this cross area tightly. Please hold tight here. I’m just going to twist this. This twist is really important! It is very important that this “Y” here is twisted firmly from here. Once it’s twisted a little bit here

, move the pliers here and twist it a little more. Go as far as you can without hurting your hands . It was twisted like this. You want to close the tip a little here, so you can use pliers like this without hurting yourself. Let’s keep it closed.

Good! Use the tip Y to twist it neatly and tightly to close it a little. In order to make a heart like this, the first twist here is very important, so start twisting it tightly and tightly so that it doesn’t come loose

. The other thing is the shape of the heart, but it depends on the “Y” here, so the rest is the length here. The length will also be proportional to the size of the heart. So if it’s too

Long, the heart will be too big and you won’t be able to tell the shape, so I think about 6mm is about right, but this also depends on the size of your nails and the curve of your nails.

I think it’s a good idea to make it for a long time at first because you’ll have to make various adjustments accordingly . Now, let’s use the rounded tip pliers to slightly modify the “Y” part here at the tip. It’s open right now, and I’m going to use these pliers to

Bend it inward a little bit. It looks like this, and I’m going to bend it a little bit inward like this. Good, good, good. Yes, I bent it like this. Create a shape that looks a little more like a “V” than a “U” than a “Y” . Then,

Check from the tip.If the tips of the wires are not at the same height, you won’t be able to make a beautiful heart, so pinch them together from the tip. If you sandwich the wires together like this, just pull them down a little . Okay, I’ll bend it just a little bit. Okay,

It’s like this. If you look at it from the side, I’m going to make the tip a little rounder so that it hangs down a little bit . Once it’s in the shape of a “V” rather than a “U”, curl the tip slightly downwards to

Make it look like this. Yes, I’ll lower it a little. As for the length here, I think it would be okay to try making a heart with this and then adjust the length as you wish to make the heart a little smaller . Yes, the left and right sides of the cat must

Be the same length for it to form a heart, so if you look at it, the left side will feel longer, so cut it a little with nippers. Good. Yes, I will cut it and adjust it so that it is approximately the same length.

Once this is done, let’s start by folding it tightly from about half way down to make it into this shape. If it’s not shaped like this, the magnet won’t form a beautiful heart, so make sure to bend it properly. Once you’ve bent it,

We’ll use the wire to make it a little more rounded so that the tip here is a little lower than where we bent it . Okay, let’s make it curve a little bit like this. The key point is to put this on your nail, and

Adjust this so that the wire at the tip and the part where it crosses here are at the same height when you put it on your nail. . As long as it’s on my nails, that’s fine. It’s a little hard to see, but I’ll do it

From an angle like this . We will adjust the position so that the points where the tips cross are exactly at the same height , so from here on we will start making fine adjustments.

Until I have a wire that I really like, I may not be able to make the heart beautifully, so I think it’s really hard to make the wire at first, but I really have to make adjustments as I make the heart. I’ll make it and then adjust the wires. Attach

A magnet to this wire . When applying it to the nail, place the magnet so that it is below the nail. If this shape is like this and the magnet is at the same height as the nail, the heart will not work properly, so the reason why I bent it here

Is so that the magnet is lower than the nail. I’ll hit it at this angle. I will apply it in this way. Okay, now that the wire is done, it’s next. Let’s make a heart right away. For today’s demo, I will be using Cocoist’s Dragon’s Eye series Purple Magenta D 03. Cocoist

Makes a lot of magnetic gels, but this Dragon’s Eye has very fine particles of magnetic powder, so I think it’s easier to make hearts appear. You can definitely make a dramatic magnet, but I think it would be best if you choose one with as fine a grain as possible. I’m shooting today, so

I’ll use this dragon’s eye to make it a little easier to understand. It’s Dragon’s Eye, but the magnetic powder itself is colored , and the gel inside is a magnetic gel with no color attached to it. So, I was planning to use a clear tip today, but

If I only use Dragon’s Eye, there is no base color, so the bottom part will show through. So today, I’ve painted the tip black to make it a little easier to understand . Yes, we will start with the black one already applied. Now let’s apply the dragon’s eye.

It’s a very fine and beautiful gel, so just applying it will turn into a very cute gel. Once you have applied the powder, use a magnet to lift the powder up from around it. Today I’m going to use a magnetic stick from Cocoist’s sister brand, Gelist . Raise the powder

So that the light is concentrated in the center as much as possible . However, for this heart magnet, it’s perfectly fine to skip this step. It might be easier to understand if you make a heart shape, so today we’ll start by gathering the light in the center.

Now, the magnet is set here, and I set it on the wire. This is the situation.The angle I applied it to earlier was so that the magnet was lower than the nail. It looks like this. I’m going to hit it at this angle. When you apply this wire

To the nail plate of your nail, it’s really slippery. The magnet won’t react unless you get it really close to the point where it sticks or doesn’t stick, so get it as close as possible and move the magnet. Yes, sometimes they stick together, so I’ll have to be a little careful.

It’s easiest to attach it to a stick , but if you attach it to something with a strong magnetic force like Cocoist’s Hyper Magnet, the magnetic powder reacts so well that all the powder scatters before the heart is formed.

It’s easy to store, so I wonder if it’s easier to use a magnetic stick like this . Also, if you find it difficult to maintain this distance, I’m not a Cocoist, but you

Can also buy magnetic sticks like this for 100 yen, so you can use them in conjunction with each other. I think so. Feel free to do this however you like. This magnet alone is enough to react. So let’s do the heart part. Now, if you bring it closer to the wire,

Just barely touch it, then hold it still for a while. As you do this, the heart will gradually emerge. If you want to adjust the shape a little at this time, just shake the wire sideways and make slight adjustments to the shape of the heart.

The most important part of fine-tuning is when you remove the wire, raise it straight up as much as possible, and the heart will pop out like this. Please let it harden as soon as possible. I think it would be a good idea to bring a handy light. Yes, it will harden once.

The magnet has hardened. I think it’s okay to apply two coats, but I think the heart line will be clearer if you finish with one coat, so if possible, I’d like to finish it with one coat. It is recommended that you do so. Finally, let’s apply Topsil. Yes, this is it. Apply

Ultra Glossy Non-Wipe Top Coat Gel . Once the top gel is applied, it will completely harden. Yes, the top gel has hardened and is finished. The heart moves slightly depending on the angle, giving it a cute finish. I think I explained at the beginning that Dragon’s Eye is transparent at the bottom, so

Only the powder itself is colored, but with this shape, I’m applying a slightly darker color to the base, and today I’m applying black. I think if you make a magnetic heart on top of something like this , it will come out quite clearly. This is a dragon’s eye

Blue based on E’s 205S Blue Hawaii, and a heart is made from that. I think it would be very cute if you painted the same clear color as the base and the heart would show through like this. The appearance changes just by changing the color of the base, so please

Try and enjoy various hearts with your favorite combinations.I thought this one would be a little easier to understand, so I demoed the one on the right today.Dragon’s eye on a black base. I made a heart out of blue, and the one on the left is Dramatic Magnet No. 11. Dramatic Plum This is

The heart I made. I tried a lot of different dramatic magnets, but this number 11 had a really good response and the heart came out really quickly and clearly, so number 11 is really cute.It has an orange magnet like this on a purple base.

Because of this, the skeleton heart is also clear and cute.You can create various expressions depending on the magnet, so please try using the heart magnet. I’m sure it’s difficult to make the wire, but please try your best. Thank you for watching until the end. Please also subscribe

To the YouTube Cocoist channel . The art director was Miki Nohara. thank you very much.

今はやりのハートマグネットネイル、案外上手に作れない人も多いのではないでしょうか？
ここが重要！っていう所を野原美樹先生が
めちゃくちゃ詳しく解説してくれています。

今までうまく作れなかった人にぜひ試して頂ければと思います。
ぜひ最後までご覧いただき、皆さんも試してみて下さいね。

KOKOISTの商品は全国のKOKOIST取り扱いネイル問屋さま、またはココイスト オンラインショップにてお買い求めいただけます。

▼KOKOIST エデュケーターリスト▼
https://www.kokoist.com/educators/

▼KOKOIST セミナー情報はこちら
kokoist_seminar.jp（Instagram）
https://www.instagram.com/kokoist_sem…

▼Lit LinkからKOKOISTの各SNSをご確認いただけます。
https://lit.link/kokoist

Please purchase products at nail dealers throughout Japan or KOKOIST online shop

◆KOKOISTオンラインショップ
https://www.kokoist.shop/

【KOKOIST JAPAN】

KOKOISTホームページ

ホーム

音源：YouTube オーディオライブラリ

#KOKOIST #ココイスト​
#ネイル #ネイルアート2024冬 #ハートマグネット